Ilma Pompa Mekkaniku Siġill Reviżjoni Nuqqas ta 'ftehim
1. The greater the amount of spring compression, the better the sealing effect. In fact, the amount of spring compression is too large, li can lead to sharp wear of the friction pair and instant burning; Excessive compression causes the spring to lose the ability to adjust the end face of the moveing ring, resulting in seal failure.
2. The tighter the moveing ring sealing ring%ring, the better. In fact, tight the move ring ring sealing ring is harmful and harmful. First, it aggravat the wear between the sealing ring and the shaft sleeve and premature leakage; Second, it increases the resistance of axial adjustment and movement of the moveing ring, and it cannot be adjusted in time when the working conditions change frequent frequent 3; Third, the the spring is is damaged by excessive fatigue; The fourth is to deform the moveing ring sealing ring ring and affect the sealing effect.
3. The tighter the static ring sealing ring, the better. The static ring sealing ring is bażikament at rest, and the sealing effect will be better when it is relatively tight, but too tight is also harmful. First, it causes the static ring seal to be overly deformed, li affects the sealing effect; Second, the static ring material is mostly graphite, li is generally brittle, and excessive force is easy to cause chipping; Third, it is difficult to install and disassemble, and it is easy to damage the static ring.

4. The tighter the impeller lock mother, the better. In mechanical seal leakage, leakage between the shaft sleeve and the shaft (shaft-to-shaft leakage) is relatively common. It is generally believed that inter-shaft leakage is that the impeller lock mother is not locked, in fact, there are many factors that lead to inter-shaft leakage, such as intershaft pad failure, offset, impurities in the shaft, large shape and position error between the shaft and the shaft sleeve fit, contact surface failure, clearance between various components on the shaft, and too long shaft head thread, etc. will lead to intershaft leakage. Excessive locking of the locking mother will only lead to premature failure of the intershaft pad, on the contrary, moderate locking of the locking mother, so that the intershaft pad always maintains a certain compression elasticity, in the operation of the locking mother will automatically lock in time, so that the shaft is always in a good sealing state.
5. The new one is better than the old. Relatively speaking, the effect of using the new mechanical seal is better than that of the old one, but the quality or material of the new mechanical seal is is not properly selected, and the large matching size error will affect the sealing effect; In polymeric and permeable media, it is better not to replace the static ring if there is no eċċessiv wear. Għax the static ring is at rest for a long time in the static ring seat, the polymer and impurities are deposited as one, li plays a a better sealing role.
6. It is better to disassemble and repair than not to dismantle at all. Once there is a leakage of the mechanical seal, it is urgent to dismantle and repair, in fact, sometimes the seal is not damaged, just adjust the working conditions or adjust the seal properly to eliminate the leakage. In this way, it not only avoids waste, but also verifies its its fault judgment ability, accumulates manutenzjoni esperjenza, u titjib il-kwalità kwalità ta' manutenzjoni.
le

